Filter
Top Products
DVG-2101S User Manual Setup
18
VoIP Setup
The VoIP (Voice over Internet Protocol) Adapter can be configured to handle
voice communication over the Internet. The screen shown below, along with the
SIP account list and phone book pages are used to configure the basic settings
to allow you to communicate with the devices that will send and receive
telephone calls over the Internet.
SIP Account List
The VoIP Adapter allows you to make calls through the Internet or PSTN. You
need to configure the SIP account before you can make a VoIP phone call.
Display Name
Enter your display name. Every outgoing call will carry this
name to the receiver and it should appear on the Caller-ID.
User Name
Enter your SIP account username. The username is the part
that comes before the “@” symbol. A username can be letters
like in an e-mail address (e.g. account@provider.com) or
numbers like a telephone number (e.g. 24680@provider.com).
Authorization
Name
Enter the authorization name to authenticate your SIP account.
This is usually the same to your SIP account’s user name.
Password
Enter the password to authenticate your SIP account.
Proxy Server
Enter the SIP proxy server’s IP address and port number in this
field (e.g. 192.168.0.253:5060).
Outbound
Proxy Server
Enter the outbound proxy server IP address and port number in
this field (e.g. 192.168.0.1:5060).
Expire Time
Enter the amount of time for the dial tone when the phone has
been lifted off the hook. At the end of this time period, if no
numbers have been dialed, the device will start playing the
busy tone.
MWI
Check the checkbox to activate MWI (Message Waiting
Indication) if the SIP server supports this service.