Filter
Top Products
17
CLEAR MSG BUTTON
In most cases the message waiting indicators will go out shortly after you retrieve your
messages. If they do not, press CLEAR MSG to clear these indicators manually.
CONTRAST BUTTON
Contrast can be altered when on hook by pressing the Contrast button on the display.
There are 8 contrast levels.
REPROGRAMMING NETWORK SERVICE BUTTONS
CALL FORWARD ON, CALL FORWARD OFF or CALL WAITING OFF can be
reprogrammed if your telephone company requires a different code. Simply follow the
instructions for programming speed dial on the following page. If you do not have one
or both of these functions, these buttons may be used as additional one-touch memory.
SPEAKER BUTTON
This button controls the speakerphone. Press once to activate the speakerphone. Press
again to deactivate.
SPEED DIAL
The 9225 can store up to 20 names and numbers in the memory buttons. Two names and
numbers can be programmed in each button.
Entering a number
1. Place the phone on hook.
2. Enter the number to be stored.
3. Press and hold the memory button or press SHIFT and then press and hold the
memory button until the last digit of the number blinks.
4. Press SAVE.
5. The cursor will blink in the name field below the number.
6. Use the keypad to enter the name or press SAVE to store with no name.
7. If a name was entered, press SAVE.
8. The display shows “SAVE OK.”
Storing a Caller ID Record or Dialed Call
1. Place the phone on hook.
2. Use the or key to display the desired number from incoming calls or dialed calls.
3. Press and hold the memory button or press SHIFT and then press and hold the
memory button until the last digit of the number blinks.
4. Press SAVE.
5. The cursor will blink in the name field below the number.
6. Use the keypad to edit the name or press SAVE to store as is.
7. If the name was edited, press SAVE.
8. The display shows “SAVE OK.”
DIAL A NUMBER FROM MEMORY
Go off hook, and press the memory button. The number will be dialed out. To dial the
second number stored in a location, go off hook, press SHIFT and then press the
memory button.