Filter
Top Products
6
8. Install the BATTERY PACK by plugging it
into the BATTERY CONNECTOR inside the
BATTERY COMPARTMENT.
9. Place the BATTERY PACK inside the
BATTERY COMPARTMENT.
10.Slide the HANDSET BATTERY COMPART-
MENT COVER firmly into place in its closed
position.
11.IMPORTANT:Before initial use, charge the
HANDSET for 12 hours.
12.TONE/PULSE Select Switch:
A. If your home is equipped with a tone
dialing system, set the TONE/PULSE
select switch to the TONE position.
B. If you have a rotary dialing system, set
TONE/PULSE select switch to the
PULSE position.
C. If you are unsure which system you have,
set the TONE/PULSE select switch to the
TONE position. Press the button
on the HANDSET to make a call. If the
call connects, leave the switch as is;
otherwise set to the PULSE position.
TELEPHONE LINE
CONNECTION
JACK
POWER-IN
CONNECTION
JACK
TONE/PULSE
SELECT SWITCH
BASE UNIT
ANTENNA
BASE UNIT
TELEPHONE
JACK
TELEPHONE LINE CORD
BATTERY
CONNECTOR
B ATTERY
COMPARTMENT
BATTERY PACK
120VWALL
OUTLET
AC ADAPTOR
Getting Started
6. Press the button to return to the STANDBY mode.
NOTE: The date and time will automatically set, if you have subscribed to the Caller ID
service from your local telephone company.
C. RINGER VOLUME
This function enables you to adjust the ringer volume from HI, LOW and OFF as
desired.
1. Press the button and hold down.
2. Press the TELEPHONE KEYPAD button.
3. Press the button.
4. Press the SCROLL UP OR DOWN button to adjust the ringer volume
suitable for your convenience. HI is the preset ringer volume.
5. Press and hold down the button.
6. Press the button to return to STANDBY mode.
D. AREA CODE
At any time during options programming of a home area code where 7-digit is used
for ease of call back, please use the following instructions if 10-digit numbers are used
in your area.
1. Press the button and hold down.
2. Press the TELEPHONE KEYPAD button.
3. Press the button.
Caller ID System Operation
21
EDIT
/FLASH
/ VOICE MAIL
/ VOICE MAIL
/ VOICE MAIL
/ VOICE MAIL
SAVE
/RE/PA
EDIT
/FLASH