Filter
Top Products
4
Safety Instructions
E. If the telephone has been dropped or the case has been damaged.
F. If the telephone exhibits a distinct change in performance.
16. Never install telephone wiring during a lighting storm.
17. Never install telephone jacks in wet locations unless the jack is specifically designed
for wet locations.
18. Never touch uninsulated telephone wires or terminals unless the telephone line has
been disconnected at the network interface.
19. Use caution when installing or modifying telephone lines.
1. Use only the following type and size BATTERY PACK:
Cordless Telephone BATTERY PACK
3.6V, 600mAh.
Ni-MH BATTERY
2. Do not dispose of the BATTERY PACK in a fire. It may explode. Check with local codes
for possible special disposal instructions.
3. Do not open or mutilate the BATTERY PACK. Released electrolyte from a BATTER
PACK is corrosive and may cause damage to the eyes or skin. Electrolyte may be
toxic if swallowed.
4. Exercise care in handling the BATTERY PACK to prevent shorting the BATTERY PACK
with conductive material such as rings, bracelets and keys. The BATTERY PACK or
conductor may overheat and cause burns.
5. Charge the BATTERY PACK provided with (or identified for use with) this telephone
only in accordance with the instructions and limitations specified in this manual.
6. Observe proper polarity orientation between the BATTERY PACK and BATTERY
CHARGER.
SAVE THESE INSTRUCTIONS.
ATTENTION:
The telephone that you have purchased contains a rechargeable BATTERY PACK. The
BATTERY PACK is recyclable. At the end of its useful life, under various state and local
laws, it may be illegal to dispose of this battery into the municipal waste stream. Check
with your local solid waste officials for details in your area for recycling options or proper
disposal.
Battery Safety
CAUTION:
Danger of explosion if the BATTERY PACK is incorrectly replaced. Replace
only with the same or equivalent type. To reduce the risk of fire or personal
injury, read and follow these instructions:
G.VOICE MAIL
This telephone enables you to store the Voice Mail Post Code number in your area.
This will automatically connect you to the Voice Mail service provider with one touch
dialing.
1. Press the button and hold down.
2. Press the TELEPHONE KEYPAD button.
3. Press the /FLASH button.
4. Enter the Voice Mail Post Code number by using the TELEPHONE KEYPAD
buttons.
5. Press and hold down the /RE/PA button.
6. Press the /RE/PA button to return to STANDBY mode.
IMPORTANT
In order to utilize the Caller ID feature, you
must subscribe to Caller ID service from
your local telephone company.
Caller ID System Operation
23
/VOICE MAIL
SAVESAVE
SAVESAVE
H. MSG Waiting (Message Waiting )
IMPORTANT:
Message waiting LCD Screen indicator will automatically turn ON if you have
subscribed to Voice Mail Message service and visual message indication from
your local telephone company.