Filter
Top Products
8
Warning: Setting this switch in a position other than OFF can cause this phone to
function incorrectly. When enabled, this feature is for PBX systems, and not meant for
direct Central Office (CO) interface. If connecting to CO telephone lines, make sure this
switch is set to OFF.
INSTALLATION
DESK MOUNT
1. Select the desired viewing angle and install the desk stand. The desk stand can be
installed in two positions to give a choice of viewing angle.
2. Connect the line cord. The line cord conncects to the jack marked LINE on the
bottom of the phone..
3. Plug the coiled cord into the handset jack, and then plug the other end of the cord
into the base.
4. Place the handset on the base.
WALL MOUNT
1. Remove the desk stand. The unit will then mount directly on a standard wall
telephone jack.
2. Rotate the handset hook into the wall mount position.
3. Plug the coiled cord into the handset, and then plug the other end of the cord into the
base.
4. Place the handset on the base.
ANSWERING MACHINE
1. Connect the LINE jack of the answering machine to the wall telephone jack.
2. Connect the LINE jack of the model 2730 phone unit to the PHONE jack of the
answering machine.
3. Set the answering machine to answer after 2 or more rings.
MESSAGE WAITING LAMP
If your phone is installed behind a Message Waiting enabled PBX, you will need to set
the M/W switch in order to receive Message Waiting indication.
1. Locate the switch on the bottom of the telephone.
2. For 90V PBX Message Waiting Indication, move the switch to the position marked
“90V”. For 24V PBX Message Waiting Indication, move the switch to the posi
tion marked “24V”. If connecting directly to telephone lines, move the switch to the
center “OFF” position.
Message Waiting Switch Location