Cortelco 2730 Telephone User Manual


 
14
RELEASE BUTTON
To end a conversation, press RELEASE once. There are two modes for RELEASE.
1. NEW CALL
In NEW CALL mode, the phone goes on-hook for 1.5 seconds and then goes off hook
again. This allows you to make another call.
2. HANG-UP
In HANG UP mode, the phone does not come back off hook. This allows you to
program a RELEASE into a speed dial location.
VOICEMAIL BUTTON
Press VOICEMAIL to dial the voicemail access number and pin. See Unit Setup
section for details.
DIRECTORY BUTTON
DIRECTORY is used to store the name and number of up to 99 of your most frequently
dialed contacts. The names are sorted alphabetically.
MESSAGE LIGHT
If you have voice mail service, the large indicator at the top of the display will flash red
to alert you that you have new messages.
The MESSAGE indicator also monitors the unit’s situation. When the phone is in use,
the MESSAGE indicator will be on continuously.
MESSAGE WAITING
When using FSK or Stutter Dial Tone (SDT) Message Waiting, the MESSAGE indicator
will flash and [MESSAGE WAITING] will appear on the display for 20 seconds when a
message is received. When using PBX message waiting (90V or 24V), there is no
indication in the display, but the light will flash.
1. FSK
The MESSAGE indicator will flash and [MESSAGE WAITING] will appear on the
display for 20 seconds when a message waiting signal is received from the Central
Office.
2. SDT
This unit will check your line for a stutter dial tone every time you hang up or each time
a call goes unanswered. The MESSAGE indicator will flash if a stutter dial tone is
detected. There may be some delay in lighting the MESSAGE indicator. This delay is
due to regulatory matters and does not indicate a problem with the unit.
This unit may not be activated or deactivated under certain conditions. For example,
when you retrieve messages from an outside phone (not your own telephone number), the
MESSAGE indicator may not be canceled when you return home. If you experience this
situation, pick up the handset and hang up. The MESSAGE indicator will cancel.