Filter
Top Products
15
RELEASE BUTTON
To end a conversation, press RELEASE once. There are two modes for RELEASE.
1. NEW CALL
In NEW CALL mode, the phone goes on-hook for 1.5 seconds and then goes
off hook again. This allows you to make another call.
2. HANG-UP
In HANG UP mode, the phone does not come back off hook. This allows you
to program a RELEASE into a speed dial location.
VOICEMAIL BUTTON
Press VOICEMAIL to dial the voicemail access number and pin. See Unit Setup
section for details.
DIRECTORY BUTTON
DIRECTORY is used to store the name and number of up to 99 of your most
frequently dialed contacts. The names are sorted alphabetically.
MESSAGE LIGHT
If you have a voice mail service with your telephone company, the large indicator at
the top of the display will flash red to alert you that you have new messages.
The MESSAGE indicator also monitors the unit’s situation. When the phone is in
use, the MESSAGE indicator will be on continuously. When the phone is ringing,
the indicator will flash quickly.
MESSAGE WAITING
This unit’s MESSAGE WAITING DETECTION is for both FSK and Stutter Dial Tone
(SDT) systems.
1. FSK
The MESSAGE indicator will flash and [MESSAGE WAITING] will appear on
the display for 20 seconds when a message waiting signal is received from
the Central Office.
2. SDT
This unit will check your line for a stutter dial tone every time you hang up or
each time a call goes unanswered. The MESSAGE indicator will flash if a
stutter dial tone is detected. There may be some delay in lighting the
MESSAGE indicator. This delay is due to regulatory matters and does not
indicate a problem with the unit.
This unit may not be activated or deactivated under certain conditions. For ex-
ample, when you retrieve messages from an outside phone (not your own tele-
phone number), the MESSAGE indicator may not be canceled when you return
home. If you experience this situation, pick up the handset and hang up. The MES-
SAGE indicator will cancel.