Filter
Top Products
11
6. When [RINGER CADENCE] appears, the default setting is 3. To alter this
setting,press REVIEW UP. There are 10 ringer cadences and each one will
be played as you scroll through them. After the desired ringer cadence is
displayed, press MENU to confirm selection.
8. When [RINGER VOLUME] appears, the default setting is 5. To alter the
ringer volume, press REVIEW UP. There are 7 ringer volume levels and
each one will be played as you scroll through them. To turn the ringer off,
select [OFF] in the Menu. After the desired ringer volume level is displayed,
press MENU to confirm selection.
9. When [VOICEMAIL NUMBER] appears, enter the voicemail number (maxi-
mum of 18 digits) using the keypad. To delete a number or digit, press
REVIEW DOWN to erase the number(s). After the desired number has
been entered, press MENU to confirm selection.
10. When [#3 SEC PAUSES] appears, enter the desired number of pauses
using the keypad. After the desired setting has been entered, press
MENU to confirm selection.
11. When [VM PASSWORD] appears, enter the desired password using the
keypad(maximum of 5 digits). To delete a number or digit, press REVIEW
DOWN to erase the number(s). After the desired number has been entered,
press MENU to confirm selection.
12. When [HOLD MODE] appears on the display. Press REVIEW UP to select
either NORMAL or PBX. In NORMAL mode, the HOLD button activates a local
hold function. This can be released at any parallel phone. In PBX mode, the
HOLD button dials a code which places a PBX line on hold. If you select PBX
mode, see Step 15 to program the code.
13. When [RELEASE MODE] appears on the display. Press REVIEW UP to
select either NEWCALL or HANGUP. In NEWCALL mode, the RELEASE button
provides a 1.5 second line break. This will ensure that the line is clear and a
new call can be dialed. In HANGUP mode, the RELEASE button drops the line
and a new connection is not made. This is primarily intended for programming
into speed dial locations.
14. When [SDT TIME] appears on the display, press REVIEW UP to change
Stutter Dial Tone timing. Please note that the default setting of 1700 mSec is
correct for most applications.
15. This only applies if you have selected PBX HOLD mode.
a. Press SAVE. The display shows [SAVE TO ?]
b. Press HOLD. The display shows [ENTER NUMBER >]
c. Dial the code using the keypad.
d. Press SAVE.