Filter
Top Products
During Memory Location Scan (while receiving an incoming
transmission), You Can Choose From The Following:
a. Press and hold the Talk button to communicate on that
memory location. Your radio will remain on that memory
location and return to
Standby mode.
b. Press the Channel Up or Channel Down button to resume
scanning memory locations.
If you press the
Talk button while scanning and not within ten
(10) seconds of receiving a transmission, you will transmit on the
memory location on which, during scanning, you last received
a transmission. This will return the radio to
Standby mode.
If you do not press any button within ten (10) seconds, your radio
will automatically resume scanning memory locations.
During Memory Location Scan (while not receiving a
transmission), You Can Choose From The Following:
a. Press and hold the Talk button to communicate on
the channel/privacy code that was displayed before you
entered mode functions or memory location on which,
during scanning, you last received a transmission.
This will return the radio to
Standby mode.
b. Press the Mode button to proceed to other functions.
c. Press the Lock button to return to Standby mode on the
channel/privacy code that was displayed before you entered
mode functions or the memory location on which, during
scanning, you last received a transmission.
To reduce the number of memory locations being
scanned, you may deprogram any unwanted locations.
(See page 12 to de-program a memory location.)
Customer Assistance WarrantyIntroduction
17
Nothing comes close to a Cobra
™
Operation
16
English
Mode Functions
Memory Location Scan
•
Your microTALK
®
radio can automatically scan up to ten (10)
programmed
Memory Locations.
If there are one (1) or fewer memory locations
programmed in your radio, the scan memory
locations option will not be available. To program
at least two (2) memory locations, see program
memory locations on page 10.
To Scan Memory Locations:
1. Press the Mode button until the Scan icon,
Memory icon and the memory location
number flashes on the display.
2. Press the
Channel Up or Channel Down
button to begin scanning memory locations.
The Scan icon and the Memory icon will
continue to be displayed when memory location
scan is
On. Your radio will continue to scan
memory locations and stop if an incoming
transmission is detected. Your radio will remain
on that memory location for ten (10) seconds.
While setting memory location scan, if you do
not press any buttons for 15 seconds, your radio
will automatically return to
Standby mode on
the channel/privacy code displayed before
you entered mode functions.
Operation
Scanning Locations
Mode Button
Channel Button