Filter
Top Products
11
Installation Steps
Installation of your ClearSounds™ CSC50 Amplified Phone is easy. There are some basic
steps you need to take when you set-up your CSC50 Phone for the first time.
1. Check parts list.
(See page #5 for complete list)
2. Install (4) AAA Alkaline batteries (not included). This provides power to the Caller ID
Screen.
3. Phone mounting installations.
4. Set the dialing mode.
5. Choose desktop or wall mount.
6. Set ringer and auxiliary alert.
7. Program your memory dial buttons.
INSTALLING THE OPTIONAL BATTERIES
The batteries are necessary in case of network power failure to save stored numbers in
memory and are required for the “Phone Book” use.
1. Begin by unplugging the AC adapter & line cord before installing new batteries.
2. Open the battery compartment door located on the bottom of your phone by un-
screwing the battery compartment door and removing it from the bottom of your
phone (screwdriver provided).
3. Insert correctly 4 AAA alkaline batteries (purchased separately) in the battery com-
partment (See figure #10). Be sure to observe battery polarity as imprinted on the
base of the compartment.
4. Replace the battery compartment door and screw back in place.
5. The batteries will last approximately 1 year before needing replacement.
BATTERY SAFETY
1. When replacing the batteries in your CSC50 phone, make sure to put the batteries
in correctly (See page above).
2. Never mix battery types (different chemistries, brands and/or fresh vs. used).
3. Never dispose of batteries in fire, as they could explode.
4. Remove worn-out batteries from equipment immediately and dispose of promptly.
5. Do not attempt to recharge a battery unless the battery specifically is marked
“rechargeable.” Dispose of immediately.
Figure #
10 – Installing the batteries