Filter
Top Products
5. Align the mounting bracket on the back of
the base so that the black rubber feet are
towards the bottom of the phone. Insert the
brackets tabs into the slots and secure the
bracket by sliding it upward.
6. Lift the bases antenna to a
vertical position.
7. Set the TONE/PULSE switch located
on the back of the base to correct
dialing mode. Please check with your
local Phone Company if uncertain of
the type of service.
8. Place handset in the cradle to begin
initial charging.
WALL MOUNTING INSTRUCTIONS
CAUTION: Disconnect the telephone line cord
before connecting or disconnecting the battery
backup in the wall mount bracket.
The base unit may be mounted on a standard
wall plate.
1. Plug one end of the supplied short
modular telephone line cord into the
TEL
jack located on the back of the base of
the phone.
2. Insert the plug of the AC adapter into the
jack marked DC 9V 400mA located on
the back of the telephone base.
3. Align the mounting bracket on the back of
the base so that the black rubber feet are
towards the bottom of the phone. Insert the
brackets tabs into the slots and secure the
bracket by sliding it upward.
4. Plug the short modular telephone line
cord into the wall plate jack, then align
the mounting brackets keyhole slots with
the wall plate studs and slide the base
of the phone downward to secure it on
the wall.
5. Plug the adapter into a standard AC
power (electrical) outlet.
6. Press and lift out the handset holder tab,
turn it around so the narrow tab end
extends out and slide back into its slot.
This will hold the handset in the cradle
when the phone is wall mounted.
7. Lift the bases antenna to a vertical
position.
8. Set the Tone/Pulse switch located on
the end of the base to correct dialing
mode. Please check with your local
Phone Company if uncertain of the type
of service.
9. Place handset in the cradle to begin
initial charging. Remember, you must
charge the phone for at least 12
hours before you use the phone for
the first time.
Getting Started
E
N
G
L
I
S
H
9