Clarity C600 Cordless Telephone User Manual


 
Telephone Operations
Answering a Call
If the handset is out of the cradle, press the
TALK button.
If the handset is in the cradle with Auto-Connect
Mode
ON, lift the handset.The handset will be
in receiver mode.
If the handset is in the cradle with AutoConnect
mode
OFF, lift the handset.The handset will be
in standby mode. Press
TALK button to receive
the call.
Refer to
BOOST Clarity Power and Volume
Control for information on adjusting volume
controls on Pages 13-19.
Last Number Redial:
The last number dialed (up to 32 digits) is
stored in the redial memory until another
number is dialed.
To use this feature:
1.
Press the TALK button.
2. When you hear the dial tone,
press the
RD/P button.
3. The phone will automatically
dial for you.
Pause Feature:
Programming in a pause will cause the
phone to wait four (4) seconds before
dialing additional numbers.This feature
may be used when it is necessary to dial
an access code (9, for example) and
wait for a second dial tone before you
can dial an outside number. Press the
RD/P button at the required point during
the memory storage process to program
a pause.
16
To Replace Battery Backup Batteries:
1. Disconnect telephone line cord and remove
desk/wall mount bracket from telephone base
2. Disconnect battery backup connector from
the telephone base
3. Remove batteries from desk/wall mount
bracket
4. Install four (4) AA Alkaline batteries with
negative (-) end of battery touching the spring
5. Connect battery backup connector to ter-
minal on bottom of telephone base
6. Install desk/wall mount bracket to telephone
base
After installing the four (4) AA Alkaline batteries
please refer to the chart below:
Placing a Call
1.
Press the TALK button (TALK button
will illuminate
GREEN) and dial the
number you wish to call.
2. To end the call press the TALK button
or place the handset in the base.
Or
1. Press the keys of the numbers needed to
dial.The
LCD will display PREDIAL and
the keys pressed.
2. Press the TALK button. Handset will go
off-hook and dialed the displayed numbers.
Power Supply
Power LED Status
AC adapter and good battereies Steady green
AC adapter and no battereies Steady red
AC adapter and bad battereies Flashing green and red
Power failure and good battereies Slow flashing red
Power failure and bad battereies Fast flashing red