Filter
Top Products
Chapter 4 Using the Call Control Window
Placing Calls from the Call Control Window
4-2
Cisco CallManager Attendant Console User Guide
OL-3053-01
Placing Calls from the Call Control Window
To place a call from the Call Control window, perform the following procedure:
Procedure
Step 1 Click the Operator Line button in the upper, right corner that indicates the
directory number of the Cisco IP Phone that controls the Cisco CallManager
Attendant Console.
Step 2 In the dialog box, enter the number that you want to dial.
Step 3 Click OK or Cancel.
Tip To place a call to a speed-dial or directory entry, drag the speed-dial or directory
entry onto the Operator Line button in the upper, right corner of the Call Control
window.
Performing Call-Control Tasks in the Call Control
Window
Table 4-1 describes the call-control tasks that affect calls in the Call Control
window. For additional information on performing call-control tasks in the Call
Control window, see the “Handling Calls” section on page 2-1.