Filter
Top Products
12-17
System Test Architecture Reference Manual for IP Telephony
OL-11591-01
Chapter 12 IP Video Telephony Configuration
Cisco Unified CallManager Configuration for IP Video Telephony
Cisco Unified CallManager Configuration Overview
The following table provides an overview of how to configure Cisco Unified CallManager for IP Video
telephony.
Region Configuration in Cisco Unified CallManager
This section provides an overview of how regions were configured in the Very Large Campus Clustering
over the WAN deployment model. These configurations were made in Cisco Unified CallManager
Administration.
For additional information about regions, refer to IP Video Telephony Solution Reference Network
Design (SRND) for Cisco Unified CallManager. (Table 12-1 provides a link to this document.)
The total bitrate for the video bandwidth of the region should be set to accommodate the total bitrate of
the video and audio RTP streams used in video calls.
Table 12-19 shows the regions matrix that was created in Cisco Unified CallManager.
Procedure Reference
Step 1
If you are not using a single Region for all call
types, configure Regions.
• Refer to the “Region Configuration” chapter
inCisco Unified CallManagerAdministration
Guide.
• Refer to the “Call Admission Control”
chapter in Cisco Unified CallManagerSystem
Guide.
Step 2
If you use locations for call admission control,
configure locations for video call bandwidth.
• Refer to the “Location Configuration” chapter
inCisco Unified CallManagerAdministration
Guide.
• Refer to the “Call Admission Control”
chapter in Cisco Unified CallManagerSystem
Guide.
Step 3
To use a Cisco video conference bridge, configure
the appropriate conference bridge for your
network.
• Refer to the “Conference Bridge
Configuration” chapter in
Cisco Unified CallManager Administration
Guide.
Step 4
To configure a user to use the video conference
bridge instead of other conference bridges,
configure the media resource groups and media
resource group lists for the user.
• Refer to the “Media Resource Group
Configuration” chapter in
Cisco Unified CallManager Administration
Guide.
• Refer to the “Media Resource Group List
Configuration” chapter in
Cisco Unified CallManager Administration
Guide.