Filter
Top Products
12-12
System Test Architecture Reference Manual for IP Telephony
OL-11591-01
Chapter 12 IP Video Telephony Configuration
Cisco Unified Videoconferencing 3540 MCU Conference Bridge Configuration for IP Video Telephony
Note The configuration shown in Table 12-7 directly affects gatekeeper call routing. If MCU Registration
Mode is not set to MCU and instead left at its default setting of Gateway, gatekeeper call routing may
not function in the Very Large Campus Clustering over the WAN deployment model.
.
To create the Cisco Unified CallManager dedicated H.323 service on the MCU, information was copied
from the existing default service prefix 87 named Continuous Presence (MP). The only change made to
this default service prefix was to change the prefix to 25. This prefix must be used when configuring
Cisco Unified CallManager route patterns, as described in the “Route Pattern Configuration for MCU
Service” section on page 12-25.
Enable alternate Gatekeeper Unchecked
Enable H.245 tunneling Unchecked
Table 12-7 Cisco Unified Videoconferencing MCU Configuration: IP/VC MCU > Protocols > H.323
Protocol Configuration > Advanced Gatekeeper Settings
Field Setting
MCU Registration Mode MCU
Table 12-8 Cisco Unified Videoconferencing MCU Configuration: IP/VC MCU > Protocols > SCCP
Protocol Configuration
Field Setting
TFTP Servers: IP Address / Port Appropriate values
CallManagers: IP Address / Port Appropriate values
Perform MCU reset on CallManager Reset
message
Checked
Local port base 11000
Priority 24
Registration: Retries 3
Initial timeout 30
Consequent timeout 10
Keep Alive: Retries 3
Timeout 10
Recovery mode Not applicable
Change configuration locally Unchecked
Table 12-6 Cisco Unified Videoconferencing MCU Configuration: IP/VC MCU > Protocols > H.323
Protocol Configuration (continued)
Field Setting