Filter
Top Products
Telco and ISP Dial Scenarios and Configurations
Large-Scale POPs
DNC-328
Cisco IOS Dial Services Configuration Guide: Network Services
interface Ethernet2/2
no ip address
shutdown
!
interface Ethernet2/3
no ip address
shutdown
!
interface Virtual-Template1
ip unnumbered Loopback0
no ip mroute-cache
peer default ip address pool dialin_pool
ppp authentication chap pap dialin
ppp multilink
!
router eigrp 10
network 10.0.0.0
passive-interface Virtual-Template1
no auto-summary
!
ip local pool dialin_pool 10.1.2.193 10.1.2.242
ip default-gateway 10.1.1.1
ip classless
!
radius-server host 10.1.1.23 auth-port 1645 acct-port 1646
radius-server host 10.1.1.24 auth-port 1645 acct-port 1646
radius-server key cisco
!
line con 0
login authentication console
line aux 0
login authentication console
line vty 0 4
login authentication vty
!
end
RADIUS Remote Security Examples
The RADIUS examples in the following sections use the Internet Engineering Task Force (IETF) syntax
for the attributes:
• User Setup for PPP
• User Setup for PPP and Static IP Address
• Enabling Router Dial-In
• User Setup for SLIP
• User Setup for SLIP and Static IP Address
• Telnetting to a UNIX Host
• Automatic Rlogin to UNIX Host
Depending on how the dictionary is set up, the syntax for these configurations might differ between
versions of RADIUS daemons.
Note You must have the async dynamic address command enabled on the network access server
if you use Framed-IP-Address to statically assign IP addresses.