Filter
Top Products
8-2
Cisco ATA 187 Analog Telephone Adaptor Administration Guide for SIP (Version 1.0)
OL-21862-01
Chapter 8 Voice Menu Codes
Table 8-1 describes the various options in the IVR Configuration Menu
Ta b l e 8-1 Navigating the IVR Configuration Menu
Action IVR Code Navigating Notes
Review or Set Network Settings 1 If DHCP is enabled, the IVR announces each
network parameter.
If DHCP is disabled, the IVR announces each
network parameter, pausing in between to allow
you to enter a new value.
1. IVR announces the IP Address. To change
the IP address for the phone, use the keypad
to enter a new IP address, followed by the #.
To retain the current IP address, press #.
2. IVR announces the subnet mask. To change
the subnet mask use the keypad to enter a
new IP address, followed by the #. To retain
the current subnet mask, press #.
Note To enter the dot “.” that separates each
octet in the IP address, press *.
3. IVR announces the default gateway. To
change the default gateway, use the keypad to
enter a new IP address, followed by the #. To
retain the current default gateway, press #.
Review or Set TFTP Server 2 IVR announces the current TFTP setting.
To change the TFTP server, use the keypad to
enter a new IP address, followed by the #. To
retain the current TFTP server, press #.
To reset a TFTP server back to the TFTP server
set by the DHCP server from a manually
configured TFTP server, press *.
Note To enter the dot “.” that separates each
octet in the IP address, press *.
Enable or Disable DHCP 3 Press 3 to toggle DHCP to enable or disable.
Review or Set the VLAN ID 4 Press 4 to review and set the Administrator
VLAN ID.
Reset to factory settings 0 —
Note All configuration settings will reset to
default factory settings, the and phone
will reset. It will take some time for the
phone to re-register. Select this option
only when needed.