Filter
Top Products
Basic Call Handling
Cisco Unified Wireless IP Phone 7925G for Cisco Unified Communications Manager 7.0 39
Tips
• To use any button to answer a call, see Changing Keypad Settings, page 74.
• You can answer an incoming call even when the keypad is locked.
• If you were using an application or service before you answered an incoming call, your application
or service will resume after you end the call.
Ending a Call
To end a call, simply disconnect. Here are some more details.
Using Hold and Resume
You can hold and resume calls. When you put a call on hold, the Hold icon appears next to the
caller ID in the call view.
If the Hold Reversion feature is enabled for your phone, calls that you leave on hold will revert back
to ringing on your phone after a certain length of time. These “reverting” calls remain on hold until
you resume them.
Your phone indicates the presence of a reverting call by:
• Alerting you at intervals with a single ring (or flash or beep, depending on your phone line setting).
• Briefly displaying a “Hold Reversion” message in the status bar at the bottom of the phone screen.
If you want to... Then...
End the call Choose , EndCall, or Options > EndCall.
Disconnect one call but preserve
another call on the same line
Choose EndCall or Options > EndCall. If necessary, remove
the call from hold first.
If you want to... Then...
Put a call on hold 1. Make sure the call you want to put on hold is highlighted.
2. Press Hold.
Note Engaging the Hold feature typically generates music or a beeping
tone.
Remove a call from
hold on the current line
(using the handset)
1. Make sure the appropriate call is highlighted.
2. Press Resume.