Filter
Top Products
25
To replace a Large-capacity Battery Pack
You must use the special large-capacity battery pack cover whenever you are using a
large-capacity battery pack to power the Pocket PC Terminal.
For information about removing and installing the large-capacity battery pack cover,
see steps 4 and 6 under “To replace the Standard Battery Pack” above.
Replacing the Backup Battery
The backup battery provides the power required to retain Pocket PC Terminal memory
contents while the main battery is being replaced, and when the main battery goes dead.
Be sure to use only a CR2032 lithium battery as the backup battery.
1.Make sure that Pocket PC Terminal power is turned off.
If power is on, press the Power key to turn it off.
2.Turn the Pocket PC Terminal over.
3.Loosen the screw securing the backup battery holder and remove the holder from the
Pocket PC Terminal.
4.Remove the backup battery from the holder. Wipe the surfaces of a new CR2032
lithium battery with a soft, dry cloth and load it into battery holder with the (+) side
facing downwards (so you can’t see it).
5.Reinstall the backup battery holder and secure it in place with the screw.