Filter
Top Products
E-37
Performing a Full Reset (Initialization)
Performing a full reset initializes memory. This means that all data stored in the
memory (RAM) is deleted and all the settings are returned to their initial factory
settings.
Perform a full reset whenever any one of the following conditions exists.
• When you want to delete all memory contents and return the settings to their initial
factory settings.
• When you are no longer able to use the Handheld Terminal because you forgot your
password.
• When the Handheld Terminal does not operate normally due to a memory problem.
• When the message “A problem with memory contents has been found. ...” appears.
To perform a full reset
Important!
Performing a full reset deletes all data currently stored in the memory (RAM). If
possible, backup data of the Handheld Terminal to a computer, Flash Memory, a
memory card, or some other medium before performing a full reset.
1. Hold down the power key and the CLR key while pushing down the reset button for
about 1 second with the stylus until the message shown below appears on the display.
• To cancel the full reset operation, press the Trigger L key.
2. Press the Trigger R key. This causes the message shown below to appear.
• To cancel the full reset operation, press the Trigger L key.
3. Press the Trigger R key again.
• Full reset is performed, all data in the memory (RAM) are erased and the start-up
screen is displayed.
Tr igger R
key
Tr igger R
key
IT600_E_P14_39.p65 05.10.25, 9:50 AM37