Filter
Top Products
General Information
5
1
f Enter the registered 4-digit PIN number
of the machine (base unit) (The factory
setting is “0000”.) by pressing the dial
pad on the control panel of the cordless
handset.
Press Menu/OK.
Note
• If you hear three short beeps, the cordless
handset did not register. Try to register the
cordless handset again.
• If you want to install another cordless
handset, repeat steps b through f.
• You can change the PIN number. (See
Modify PIN on page 24.)
• You can register any GAP (Generic
Access Profile) compatible DECT™
handset to your machine (base unit).
Follow steps a and b, then refer to your
handset documentation to complete the
registration. Functions are limited to
making and receiving external calls.
g Press Stop/Exit on the control panel of
the machine (base unit).
For Colour LCD model
1
a Press Menu on the control panel of the
machine (base unit).
b Press a or b to choose
Initial Setup.
Press OK.
c Press a or b to choose
Register Handset.
Press OK.
d Press a or b to choose Register.
Press OK.
The machine (base unit) searches for
the cordless handset.
e Press Menu/OK on the cordless
handset.
f Press a or b to choose Register HS.
Press Menu/OK.
g Press a or b to choose Base1, Base2,
Base3 or Base4.
Press Menu/OK.
Note
• If you have already registered the handset
to a base unit, make sure you choose a
base unit number that is not being used.
For example, if you register the handset to
an additional base unit and you choose
Base1, the base unit previously stored in
Base1 will be overwritten and the handset
will no longer be connected to it.
• Your machine (base unit) is already stored
as Base1 on the included handset.