Filter
Top Products
16
SETTING UP
Synergy 3500 user guide ~ 3rd Edition ~ 21st October ’02 ~ 4461
Please see the table below for your
Synergy 3500 default settings.
If you wish to personalise your
answering machine settings, for
example record your own outgoing
message etc, please see “Setting up
and personalising your answering
machine” beginning on page 35.
The answering machine will now be
switched ON and set to its default
settings so your Synergy 3500 is now
ready for use.
Synergy 3500 Default Settings Table
Feature Default Setting
Day/Time Stamp Sunday 12:01 pm
Answer Delay Your answering
machine will answer
after 6 rings
Audible Message
Alert Tone
OFF
Outgoing Message Answer and Record
“Hello your call cannot
be taken at the
moment so please
leave your message
after the tone.”
Answer Mode ON
Base ringer level High
Base loudspeaker
volume
Level 5
PIN code 0000
Dialling mode Tone
If you wish to register additional
handsets, please see page 53.
Additionally, if you have
purchased the Synergy 3500
Twin:
1. Connect the power supply to the
charger (item code 003313).
Plug the power adaptor into the mains
power socket on the underside of the
charger.
Plug the adaptor into the mains power
supply and switch on.
2. Install the rechargeable batteries in
the handset.
3. Charge the handset batteries for at
least 16 hours.
Your Synergy 3000 additional handset
comes pre-registered to the main base
station as SYNERGY HS2. This will be
shown on the display.
Your Synergy 3500 Twin
is now ready for use.
Note
The charger must be plugged into the
mains power socket at all times.