BT Versatility
Installation and Maintenance Manual
47
Programming
Essential programming is carried out either from a Featurephone connected to extension 20 or via the BT
Versatility wizard, the programming PC application.
Ensure that the following programming is done.
Equipped exchange lines
The system assumes that all line cards have lines connected to them. If lines are not connected, it is vital
to unequip these lines in system programming, as follows:
• From the programming position, press the phone programming key
select ‘System programming’.
• Enter the PIN and select ‘Lines’.
• Select ‘Equipped lines’.
• Equipped lines are denoted by ♦. Unequipped lines are denoted by ◊.
• Press
HANDS FREE to finish programming.
Incoming ringing
The phones to be rung for incoming calls are programmed as follows
• Select 'Lines'
• Select 'Incoming Ringing'
• Select the Line or Access
• Select 'Day mode', 'Night Mode' or 'Day and Night mode'
• Select whether the line is to ring an extension or Group. If the Line is to be presented to the Auto
Attendant or Courtesy service it is selected here.
Note that the first 8 extensions are in group 1 as default. To change the extensions in a group, select
'Lines' and then 'Group Programming'.