Filter
Top Products
11
3
Charge the handset battery
for at least 16 hours
Before you use your Synergy 2100 for
the first time, it is important to have
the handset battery fully charged.
We recommend that you leave the
Synergy 2100 on charge for at least
16 hours.
Place the handset on the charging
cradle, when charging, the battery
level symbol is shown. It flashes
during charging. Once the handset is
fully charged, the display shows a full
battery symbol.
0-50%
0%
(flashing)
50-100%
100%
Battery levels
Battery low warning.
If the handset battery symbol is
empty and flashing, and you hear a
warning beep every 10 seconds, you
will need to recharge your handset
before you can use it.
Battery performance
After charging your Synergy 2100
handset for the first time, subsequent
charging time for the battery is
approximately 4-5 hours. Battery and
case may become warm during
charging. This is normal and not
dangerous.
Under ideal conditions, the handset
battery should give about 12 hours
talktime (7 hours in handsfree mode)
or 150 hours standby on a single
charge.
Please note, however, that a new
NiMH battery does not reach its full
capacity until it has been in normal
use for several days.
Please note that while the NiMH
rechargeable battery can be expected
to give years of service they do not
last forever.
Their actual lifespan depends on
how heavily they are used but over
time, their capacity to recharge will
begin to diminish and they will
eventually need replacing.
Synergy 2100 - Edition 3 – 31st May ’00
SETTING UP
Synergy 2100 1/6/2000 3:07 pm Page 9