Filter
Top Products
Voice Portal
The above information is provided by AVAYA Inc. as a guideline. See disclaimer on page 1
3
5.0 CONFIGURING THE PBX TO INTEGRATE
The following tasks must be completed when programming the PBX to integrate.
IMPORTANT NOTE: Although the integration uses the IP Softphone protocol for
connectivity, they are defined within the PBX as 4-wire 7434ND (numeric
display) sets.
The tasks are as follows:
• Configure Switch System Settings
• Create Pilot number for the Voice Portal hunt group.
• Define the stations assigned to Voice Portal.
NOTE
: A number of configuration shows screens that follow are shown
displayed in the Avaya Site Administration GUI, also known as GEDI
(Graphically Enhanced DEFINITY interface). Screens and parameters
may appear different depending on PBX software revision and load.
Please note, for those using Definity System Administration the tabs on
the following screens correlate to the page #s as displayed on the admin
screens.
5.1 SYSTEM PARAMETER FEATURES
Under Parameters double-click change system-parameters features.
Select tab 5 and verify that the field 7434ND? is set to “y”
Figure 1: System Parameters Features - Tab 5
Configuring the PBX
to integrate