Filter
Top Products
38
Handset Administration
Handset Administration
FAQs
How does the handset power off and power on?
The END key is the power on/power off key. Press and hold it to turn the
handset on. Turn the handset off from the standby mode by pressing and
holding the END key. If you are in an active call, end the call by pressing
the END key. This returns the handset to the standby mode.
How do I place a call and terminate a call?
To place a call, press the START key and then dial the number. End the
call by pressing the END key. You can also use the speakerphone instead
of the START key.
Can I change the ring?
The ring is fully adjustable and may be set differently for different profiles.
For a complete explanation of how to change the ring, see the Profile Set-
tings section of this guide.
How do I change the voice volume and the ringing volume?
Whether using a headset, the speakerphone, or the internal speaker, the
speaker volume for the current call may be raised or lowered by pressing
the up and down volume buttons on the side of the handset.
The volume buttons may be pressed while the handset is ringing to raise
or lower the ring volume, which also changes the ring volume setting in
the current profile.
What is the range of the Avaya 3641/3645 Wireless IP
Telephone?
As barriers affect radio transmission, there is no single answer for this
question. Normally, you can expect the same range as with any other wire-
less device. However, if your facility has metal walls or other materials
that inhibit radio waves, the range will be reduced.
How do I charge the Battery Pack?
The Battery Pack in the handset may be charged in a Single or Dual
Charger without being removed from the handset by simply placing the
handset into the charger. A spare Battery Pack may be charged in the rear
bay of the Dual Charger or in a Quad Charger.
21-601633_1.book Seite 38 Freitag, 13. Juli 2007 4:42 16