Filter
Top Products
Avaya Inc. Desktop Charger, Dual Charger, and Quad Charger User Guide
Incoming PBX call
during a PTT call
A telephone call may be answered while in a PTT call session. To
announce an incoming call, the WT will ring with a low-volume
ring and display the system message.
To answer the call, press
Start Call. The PTT call session will be
pre-empted and no PTT audio will be heard.
After the PBX call is over, press
End Call as usual to go back on
hook, at which time PTT goes out of pre-empted mode and
becomes active again. If an already active PTT call has not
ended, the PTT audio starts playing again.
If the user does not answer the telephone call by pressing
Start
Call
, the PTT display will be shown after the ring has stopped.
Making a PBX call
during a PTT call
To start a telephone call during a PTT call session, press the
Start
Call
key. This causes the two-way radio to be pre-empted as
described above.
Incoming PTT call
during a PBX call
The PTT “receiving alert” sound will play softly in the speaker
audio, if a PTT session is started during a PBX call. You may
continue your PBX call normally, or you may switch to the PTT
call by ending the PBX call by pressing the
End Call button.
21-300632, Issue 1, July 2005 Page 19