Filter
Top Products
Interface Control
Issue 1 June 2007 85
11. Press the # button to save the new values you entered.
The telephone displays:
Once the new values are stored, the telephone is reset.
If a new boot program is downloaded from the HTTP server after you enter static
addressing information, you must reenter your static addressing information.
Disable/Enable Event Logging
Use the following procedure to enable or disable logging of system events.
1. While the telephone is on-hook and idle, press the following sequence of keys on the
faceplate of the telephone:
Mute 5 6 4 # (Mute L O G #)
Note:
Note: Press the Mute button momentarily. Do not press this button while pressing other
keys/buttons.
2. After entry of the command sequence, the telephone displays the following text, depending
on the current value of the system parameter NVLOGSTAT:
where status is the type of logging indicated by the NVLOGSTAT value, defined as:
● Status is disabled when NVLOGSTAT = 0
● Status is emergencies when NVLOGSTAT = 1
● Status is alerts when NVLOGSTAT = 2
● Status is critical when NVLOGSTAT = 3
● Status is errors when NVLOGSTAT = 4
● Status is warnings when NVLOGSTAT = 5
● Status is notices when NVLOGSTAT = 6
● Status is information when NVLOGSTAT = 7
● Status is debug when NVLOGSTAT = 8
New values
being saved
Log=status
*=change #=OK