Filter
Top Products
Wireless Phone Configuration
Wireless Installation and Configuration Guide Page 37
IP Office [15-601082] Issue [1] (1 June 2006)
Admin Menu
Items
Second Level
Third Level Fourth Level
Fifth Level
Sixth
Level
*Diagnostics
Off
Syslog mode *Disabled
Errors
Events
Full
Restore
Defaults
IP Address
There are two modes in which the wireless phone can operate: DHCP enabled or static IP. Select the
mode for operation from the IP Address menu:
* Use DHCP
Will use Dynamic Host Configuration Protocol (DHCP) to assign an IP address each time the wireless
phone is turned on. If DHCP is enabled, the wireless phone also receives all other IP address
configurations from the DHCP server.
Static IP
A static IP address allows you to manually set a fixed IP address. If selected, the wireless phone will
prompt for the IP address of each of the configurable network components. When entering addresses,
enter the digits only, including leading zeroes. No periods are required.
Regardless of the mode in which the wireless phone is operating, the following components must be
configured.
Phone IP
Phone IP refers to the IP address of the wireless phone. This is automatically assigned if DHCP is used.
If using static IP configuration, you must obtain a unique IP address for each phone from your network
administrator.
AVPP IP
AVPP IP refers to the IP address of the AVPP. If using static IP configuration, this is simply the IP
address of the AVPP.
Note
The AVPP must be statically configured to have a permanent IP address. If DHCP is being used,
the wireless phone will try the following, in order: the DHCP option 151, then a DNS lookup of
“SLNKSVP2” if the DHCP options 6 (DNS Server) and 15 (Domain Name) are configured.
The following components may be configured optionally: