Filter
Top Products
AEW-T1000 UHF TRANSMITTER
Power On/Off
To turn the transmitter on, hold the Power/Mute button until
the red power indicator and the LCD window come on (about
1–2 seconds). The operating frequency shows in the window
after the power-up sequence.
To turn the transmitter off,
hold the Power/Mute button again,
until the red power indicator and the LCD window are
extinguished (about 1–2 seconds). The LCD window shows
“
PWR.OFF” before shutdown.
Mute On/Of
f
When the transmitter is muted, it produces RF with no audio
signal modulation. When the transmitter is un-muted, it
pr
oduces both RF and audio.
To mute the transmitter (cut off the audio, but continue the RF
output),
touch the Power/Mute button once. A small “MUTE”
appears in the LCD window
, just below the frequency (Figure
H-2).
To un-mute the transmitter (restore the audio),
touch the
Power/Mute button
once again. The “MUTE” disappears from
the LCD window.
Refer to Figures H through Q for an overview of transmitter
functions and controls.
LCD Window
The Liquid Crystal Display presents a great deal of setup and
operating information clearly and conveniently (Figure H). The
LCD in the transmitters is designed for greatest contrast and
best viewing with the window rotated somewhat
away from
the viewer (about 30 degrees), not straight-on, for a more
convenient holding/viewing position.
Power/Mute Button
The transmitters have a combination Power and Mute switch
(Figure J/K). When used in combination with the programmed
choices explained below, the various functions available to the
transmitter user may be tailored to fit personal preferences or
particular situations.
T
ransmitter Controls and Functions
18
Batter
y Door
LCD W
indow
Figur
e J
Antenna
Audio Input Jack
Mounting Clip
Set Button
Power/Mute
Button
Up/Down
Arrows
Sliding
Control Cover
(3-position)
Power-on LED
Figure K
LCD
W
indow
Power-on
LED
Power/Mute
Button
Antenna
Housing
H-1. Normal Operation
* AEW-T1000 only: “INST”
H-2. Operation with Mute On
H-4. Edit Mode (Frequency)
Figure H
BATT MIC
B
H-3. Menu Mode (Frequency)
BATT MUTE MIC
B
BATT MIC
MENU
BATT MIC
EDIT
Flashing
▼
*
▼
▼
Touch: A momentary press of the Mode/Set button. It is
used to enter Menu mode, to enter Edit mode, or to Escape
without making any changes to current settings.
Hold: A pr
ess and hold (about two seconds) of the Mode/Set
button. It is used to accept a new setting when the r
eceiver
is in Edit mode or to save the cur
rent settings to one of the
five user-defined name presets or the internal memory
location (“NAME?”).