Filter
Top Products
Answering system setup
Message alert tone
When the message alert tone is set to On, and
there is at least one new message, the telephone
base will beep every 10 seconds. Unless you
change it, the message alert tone is set to off.
To change the setting:
1. Press SETUP four times. The system will
announce "Message alert tone," followed by
the current setting, and then "To change the
setting press SKIP or REPEAT; to continue
setup, press SETUP."
2. Press SKIP or REPEAT to change between
on and off.
3. Press SETUP to save your selection and move
to the next menu option.
-OR-
Press
PLAY/STOP to save your selection
and exit the menu.
Temporarily turning off the message alert tone
Pressing any telephone base key (except
HANDSET LOCATOR) will temporarily silence
the message alert tone.
If you press DELETE in idle mode, there will be
a voice prompt to direct you to press DELETE
again to delete all old messages, and the
message alert tone will be temporarily silenced.
The message alert tone will be re-activated with
the next incoming message.
Answering system operation
45
NOTE:
The message alert tone will
beep only if all the conditions
below are met:
Answering system is on.
Message alert tone setting
is on.
There are new messages.