Filter
Top Products
Answering system operation
38
Day & time announcement
To check day & time
You can press CLOCK when the system is idle to
hear the current day and time.
If you subscribe to caller ID service from
your local telephone company, the time will
automatically be set with every incoming call.
You must set the year so that the day of the
week can be calculated from the caller ID
information.
If you do not hear the correct time, day, and
year, follow the steps below.
To set day & time
Before playing each message, the answering system
announces the day and time the message was
received.
Follow the steps below to set the year, time and
day, so the day and time are correct. Each time you
press SKIP or REPEAT, the year, hour, minute
or day increases or decreases by one. Press and
hold SKIP or REPEAT to increase or decrease
the minutes or year by increments of ten. When
you hear the correct setting, press CLOCK to move
to the next setting.
1. Press CLOCK, the system will announce the
current clock setting, and then announce “To set
the clock, press CLOCK.”
2. Press CLOCK, The system will announce the
current year setting, and then announce “To
change the year, press SKIP or REPEAT, to
change the hour, press CLOCK.”
3. Press CLOCK, The system will announce the
current hour setting, and then announce “To
change the hour, press SKIP or REPEAT, to
change the minute, press CLOCK.”
4. Press CLOCK, The system will announce the
current minute setting, and then announce “To
change the minute, press SKIP or REPEAT, to
change the day, press CLOCK.”
5. Press CLOCK, The system will announce the
current day setting, and then announce “To
change the day, press SKIP or REPEAT, press
CLOCK when you are done.”
6. Press CLOCK. The system announces the
current clock setting.
NOTE: If the clock was
not set when a message
was recorded, the
system will announce
"Time and day not set"
before the message is
played back.