AT&T SL82658 Cordless Telephone User Manual


 
6
Getting started
Telephone base & charger installation
Install the telephone base as shown below. Make sure that the electrical
outlet is not controlled by a wall switch.
If you subscribe to high-speed Internet service (digital subscriber line - DSL)
through your telephone lines, you must install a DSL filter between the
telephone base and the telephone wall jack. The filter prevents noise and
caller ID problems caused by DSL interference. Please contact your DSL
service provider for more information about DSL filters.
The telephone base comes with the mounting bracket installed for desktop
use. Also, the telephone line cord and the power adapter are already plugged
into the telephone base. If you want to change to wall-mounting installation,
see page 11 for details.
Telephone base installation
1. Plug the other end
of the telephone
line cord into a
telephone jack.
2. Plug the power
adapter into an
outlet not controlled
by a wall switch.
Power
adapter
DSL filter (not included),
required if you have DSL
high-speed Internet service.
Telephone
line cord
3. Make sure the
telephone line cord
and power adapter
cord are routed
through the slots
on the bracket.
4. Raise the antenna.