Filter
Top Products
35
Answering system operation
-OR-
1.
SETUP
Press until desired fea-
ture is heard (see list
at right).
3.
SETUP
Press to set selec-
tion and move to next
menu option.
Changing feature options
You can change how the answering system operates.
Press SETUP repeatedly to hear each feature. When you
hear the feature you want to modify press SKIP or
REPEAT to change the setting. Press SETUP to confirm
your selection and move to the next menu option or press
PLAY/STOP to confirm your selection and exit the
menu.
Feature options (Default settings underlined).
System announces: Feature description:
"Number of rings," current
setting, then "To change
the setting press SKIP
or REPEAT; to continue
setup, press SETUP."
Options: 2/4/6/toll saver
“Base ringer,” current
setting, then “To change
the setting press SKIP
or REPEAT; to continue
setup, press SETUP.”
Options: high/low/off
"Remote access code,"
current setting, then "To
change the setting press
SKIP or REPEAT; to con-
tinue setup, press SETUP."
Options: (select two-digit
code) 19
"Message alert tone,"
current setting, then "To
change the setting press
SKIP or REPEAT; to con-
tinue setup, press SETUP."
Options: on/off
Choose number of rings before the
system answers a call. When toll
saver is active, the system answers
after two rings if you have new mes-
sages, and after four rings if you have
no new messages. When retriev-
ing messages from a long-distance
call, you may disconnect your call
after three rings so that long dis-
tance charges will not be charged.
Choose base ringer volume to high or
low level, or turn the base ringer off.
Select a two-digit number (10-99)
for remote access from another tel-
ephone (page 40).
NOTE: Press and hold SKIP or
REPEAT to increase or decrease the
remote access code number by incre-
ments of 10.
When on, the telephone beeps every
10 seconds when there are new mes-
sages.
NOTE:
The message alert tone will beep only if all the conditions below are met:
Answering system is on.
Message alert tone setting is on.
There are new messages. Pressing any telephone base key (except HANDSET LOCATOR) will
temporarily silence the message alert tone. If you press DELETE in idle mode, there will be a voice
prompt to direct you to press DELETE again to delete all old messages, the message alert tone will
be temporarily silenced. The message alert tone will be re-activated with the next incoming message.
Press until desired
selection is heard.
2.
SKIP or
REPEAT
Press to set selection
and exit menu.
PLAY/STOP