Filter
Top Products
33
Answering system operation
Day & time announcement
To check day & time
You can press CLOCK when the system is idle to
hear the current day and time without changing it.
To set day & time
Before playing each message, the answering system
announces the day and time the message was
received.
Follow the steps below to set the year, time and day,
so messages are dated correctly. Each time you press
SKIP or REPEAT, the year, hour, minute or day
increases or decreases by one. Press and hold SKIP
or REPEAT to increase or decrease the minutes or
year by increments of ten. When you hear the correct
setting, press CLOCK to move to the next setting.
1. Press CLOCK, the system will announce the
current clock setting, then announces “To set the
clock, press CLOCK.”
2. Press CLOCK, The system will announce the cur-
rent year setting, then announces “To change the
year, press SKIP or REPEAT, to change the hour,
press CLOCK.”.
3. Press SKIP or REPEAT, until the system
announces the correct year, then press CLOCK.
4. Press SKIP or REPEAT, until the system
announces the correct hour, then press CLOCK.
5. Press SKIP or REPEAT, until the system
announces the correct minute, then press CLOCK.
6. Press SKIP or REPEAT, until the system
announces the correct day, then press CLOCK.
The system announces the current clock setting.
NOTES:
1. If the clock was not set when the message was recorded, the
system will announce "Time and day not set."
2. Caller ID provides the time and date. Set the year so that
the day of the week can be calculated from the caller ID
information. After you set the time once, it will thereafter be set
automatically with incoming caller ID information. The time
will be set automatically only if you subscribe to caller ID
service provided by your local telephone company (page 28).