Filter
Top Products
3
Installation
Install the telephone base and charger as shown below. If you subscribe to high-speed
Internet service (DSL - digital subscriber line) through your telephone line, you must
install a DSL filter on the DSL line. If you want to mount your telephone on a wall, use
the included wall mount bracket and refer to Wall mount installation in the online
user’s manual for details.
Telephone line cord
A DSL filter (not included)
is required if you have DSL
high-speed Internet service.
Telephone wall jack
Plug one end of the
telephone line cord
into the TEL. LINE
jack on the bottom
of the telephone
base.
Plug the other end of
the telephone line cord
into a telephone wall
jack.
Plug the small
end of the larger
power adapter into
the power jack on
the bottom of the
telephone base.
Electrical outlet not
controlled by a wall
switch
Plug the large end
of the larger power
adapter into an
electrical outlet not
controlled by a wall
switch.
Route the cords
through the slots.
Plug the large end
of the smaller power
adapter into an
electrical outlet not
controlled by a
wall switch.
Ensure the small end
of the smaller power
adapter is plugged
into the power jack
on the bottom of the
charger.
IMPORTANT INFORMATION:
Use only the power adapters provided with this
product. To obtain a replacement, visit our website at
www.telephones.att.com or call
1 (800) 222-3111. In Canada, dial
1 (866) 288-4268.