Filter
Top Products
FCC Part 15
This equipment has been tested and found to comply with
the requirements for a Class B digital device under Part 15 of
the Federal Communications Commission (FCC) rules. These
requirements are intended to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Increase the distance between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications to this equipment not expressly
approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
To ensure safety of users, the FCC has established criteria for the
amount of radio frequency energy that can be safely absorbed by a
user or bystander according to the intended usage of the product.
This product has been tested and found to comply with the FCC
criteria. The handset may be safely held against the ear of the user.
The telephone base shall be installed and used such that parts of
the user’s body other than the hands are maintained at a distance
of approximately 20 cm (8 inches) or more. If you choose to use
a clipping device, please make sure to only use the supplied AT&T
belt clip.
27