AT&T E5640 Cordless Telephone User Manual


 
Re-registering a handset
To re-register a handset to a new telephone base
Make sure the handset battery is properly installed and
charged.
Unplug the old telephone base. The handset will display
SEARCHING....
Install the new telephone base by plugging it into an electrical
outlet and telephone jack.
Press and hold the
SELECT/MENU key until the handset displays
ENTER BASE ID.
Enter the 15-digit base ID code located on the bottom of the
E5640, E5643B and E5644B telephone base. To find the number
on the E5655, go to the telephone base, press
SELECT/MENU
on the telephone base and scroll down to highlight DISPLAY
BASE ID, then press SELECT/MENU.
After entering the code, press SELECT/MENU to accept the
code and complete registration.
NOTE: If an invalid base ID code is entered, you will hear an error tone and the
handset will continue to display ENTER BASE ID. To make corrections while entering
the code, erase digits by pressing the DELETE/MENU key.
Once a valid base ID code is entered and accepted by the
telephone base, the new handset will be assigned the next
available handset number (Handset 2, Handset 3, or Handset
4). A maximum of four handsets can be registered to each
telephone base.
10