AT&T CL82209 Cordless Telephone User Manual


 
Appendix D
55
Troubleshooting
The batteries do
not hold a charge.
If the cordless handset is in the telephone base or
charger and the charge light is not on, refer to The
charge light is off (page 58) in this Troubleshooting
guide.
Charge the battery in the cordless handset for at
least 16 hours. For optimum daily performance,
return the cordless handset to the telephone base or
charger when not in use.
If the battery is depleted, it might take approximately
10 minutes to charge the handset before it shows
LOW BATTERY, refer to the table on page 6 for
details.
You might need to purchase a new battery. Please
refer to Battery installation & charging in this user’s
manual on pages 6-7.
CONNECTING...
appears on my
cordless handset.
Ensure you plug the telephone base in properly and
the power is on.
Place the cordless handset in the telephone base for
one minute to allow the cordless handset and base to
synchronize.
Move the cordless handset closer to the telephone
base. You might have moved out of range.
Reset the telephone base. Unplug the electrical
power. Wait for 15 seconds then plug it back in.
Allow up to one minute for the cordless handset and
telephone base to reset.
Other electronic products can cause interference
with your cordless phone. Try installing your phone as
far away from these types of electronic devices as
possible: television sets, VCRs, or other cordless
telephones.
The handset
screen shows
PRESS HNDST
LOC 4 SEC ON
BASE and the
handset is out of
the telephone
base or charger.
Unplug the battery from the handset and plug it back in
(page 6). The screen should now show NOT
REGISTERED and you can follow the registration
instructions on page 51.