Filter
Top Products
19
ANSWERING SYSTEM OPERATION
AT THE BASE
Saving Messages
The system saves your messages automatically until you delete them, and can
store approximately 15 minutes of messages, memos and announcements (up
to a maximum of 99 messages). When memory is full, or the maximum
number of messages is recorded, the Message Window flashes F (for Full) and
the number of messages. You’ll need to delete messages to make room for new
ones. (Messages are saved even if the power adapter is unplugged, or in the
event of a power failure.)
NOTE: When full, the system automatically turns off. The system answers
calls after 10 rings and prompts “Memory full. Please enter your security
code.” You can now access your system remotely, even though it’s set to
off. (See ANSWERING SYSTEM OPERATION – FROM A REMOTE TOUCH
TONE PHONE.)
Deleting Messages
Delete all messages
Press and hold D to delete all old messages. The system will not delete
messages that have not been played.
Delete selected messages
Press and release D while the message you want to delete is playing. The
system continues with the next message.
Recording a Memo
You can record a memo to be stored as an incoming message. The memo can
be up to 4 minutes long, and will be played back with other messages.
1 Press and release M. The system prompts “Now recording,”
followed by a beep.
2 After the beep, speak toward the microphone.
3 To stop recording, press and release Y.
9050_book.1AT&T 8/12/98, 4:15 PM19