AT&T ATT993 Conference Phone User Manual


 
15
Getting started
Check for a dial tone.
Press LINE 1 then lift the handset, or press SPEAKER and listen for a dial
tone. Then press LINE 2 and listen for a dial tone. If there is no dial tone,
see Troubleshooting on page 58.
Confirm Lines 1 and 2.
Press LINE 1 and dial one of the telephone numbers. If there is a busy
signal, line 1 is the number you called. If line 2 rings, line 2 is the number
you called.
6.
7.
Use only the power adapter supplied with this product. To order a replacement power
adapter, visit our website at www.telephones.att.com, or call
1 (800) 222-3111. In Canada, dial 1 (866) 288-4268.
Be sure to use an electrical outlet not controlled by a wall switch.
This power adapter is intended to be correctly oriented in a vertical or floor mount position.
1.
2.
3.
NOTES:
Wall mounting
If there are two separate one-line wall jacks, use two telephone
line cords. Plug one end of the clear telephone line cord into the jack
labeled L1 or L1/L2 on the back of the telephone. Plug one end of
the black telephone line cord into the jack labeled L2 on the back of
the telephone. Route the cords through the channel on the bottom of
the telephone. For line 2 you will need to lift up the bracket and put
the cord through the hole in the bracket. Then, route the cord through
the channel so it comes out at the bottom of the phone and return the
bracket to the wall mount position. Plug the free end of the telephone
line cord for Line 1 into the Line 1 wall jack. Plug the free end of the
telephone line cord for Line 2 into the Line 2 wall jack. Make sure the
telephone line cords snap firmly into place at both ends. Place the
telephone on the wall mounting plate and pill down until it is held
securely.
Modular
wall jack
for Line 1
L1
Modular
wall jack
for Line 2
L2