Filter
Top Products
Table/Desk Installation
continued from page 5
4 Connect the handset to the telephone.
Plug the coiled handset cord into the handset jack on the left
side of the phone. Plug the other end of the coiled cord
into the handset, then hang up.
5 Check for dial tone.
Lift the handset and listen for a dial tone. If you cannot hear
a dial tone, press VOLUME +. If you still do not hear a dial tone,
see the IN CASE OF DIFFICULTY section of this manual.
Your phone will work immediately after installation using the default feature
settings (See “Default Settings” on page 31).
NOTE: If you subscribe to Caller ID services from your local telephone
service provider, you must follow the instructions in “Set Home Area Code”
for your phone to properly recognize and dial calls (see page 11). You may
also need to “Set Local Area Codes” (see page 12).
6
INSTALLATION
INSTALLATION
handset jack