Filter
Top Products
3
INSTALLATION
Use only the power cord supplied with this product. If you need a
replacement,call 1 800 222–3111.
3 Charge the handset battery.
Place the handset in the base. Charge the battery for at least 24 hours
the first time. After the first charge,the battery is typically fully
charged overnight.
4 Check for dial tone.
After the batteries are charged, pick up the handset and press P;
you should hear a dial tone.
5 Set the dial mode.
If you have touch tone service,the phone is ready to use as soon as
the batteries are charged.
If you have dial pulse (rotary) service,you’ll need to change the dial
mode. When the phone is off, press G, *, #,M to set the
dial mode to dial pulse. To return to touch tone dialing, press
G,*, *, M.
Modular
telephone jack
Standard
electrical
outlet
Table/Desk Installation
1 Connect the telephone
line cord.
2 Connect the power cord.
The ANSWER ON/OFF light
goes on,and CL flashes in the
Message Window.
9353_book_1ATT 6/7/01 1:56 PM Page 3