Filter
Top Products
17
BATTERIES
Charging the Handset Battery Pack
This battery should remain charged up to six days with the ringer turned
on and up to 12 days with the ringer off. A fully charged battery provides
an average talk time of about six hours.
The battery pack needs charging when:
• A new battery is installed in the handset.
• The phone beeps twice when you press P.
• The phone light flashes slowly.
Place the handset in the base so the CHARGING light turns on. The battery
pack is typically fully charged in eight hours.
You can keep the battery fully charged by returning the handset to the
base after each use.
If you repeatedly get a low battery indicator, even after eight hours of
charging,the battery should be replaced. Use only AT&T battery 3301
(SKU# 91076).
CAUTION: Charge the battery provided with or identified for use
with this product only in accordance with the instructions and
limitations specified in the User’s Manual,Part 1.
Replacing the Handset Battery Pack
1 Remove the battery compartment cover on the handset by press-
ing on the indentation and sliding the cover downward.
2 Lift out the old battery pack and disconnect.
3 Plug battery pack connector into handset. Place the battery pack
and wires in the compartment.
4 Replace the cover by sliding it up into place.
5 The new battery pack must be charged before using the phone.
Place the handset in the base and allow it to charge for at least 24
hours the first charge. The telephone might operate before that, but
for best performance, let the battery pack charge fully.
9353_book_1ATT 6/7/01 1:56 PM Page 17