Filter
Top Products
6
INSTALLATION
the excess line cord under the tab on the bottom of the telephone
base. Plug the line cord into your other one-line wall jack. You
will be connected to Line 2.
5 Mount the telephone on the wall jack.
Position the telephone base so the mounting studs on the wall jack fit
into the base of the telephone. Slide the telephone down on the
mounting studs until the phone locks into place.
6 Follow Steps 7 and 8 under Table/Desk Installation.
CAUTION: Use only the AC power adapter supplied with this
telephone. Class 2 Power Source. Input: AC 117V, 60 Hz, 9W Output:
DC 9V, 500mA
Belt Clip
If you wish, you can attach the belt clip to the cordless handset, following
the illustrations below.
To Remove
To Attach
9002_book.1AT&T 8/12/98, 4:09 PM6