Filter
Top Products
4
4 Connect the telephone line cord(s) to the base.
• If you have a two-line jack, use only the white line cord. Plug
one end into the jack labeled L1/L2 on the back of the base.
• If you have two separate jacks, use both the white and clear
line cords. Insert one end of the white line cord into the jack
labeled L1/L2 on the back of the base. Plug one end of the clear
line cord into the jack labeled L2 on the back of the base.
5 Connect the telephone line cord(s) to the modular telephone
jack(s).
• If you have a two-line jack, plug the free end of the white
line cord into the modular telephone jack. Make sure the cord
snaps firmly into place.
• If you have two separate jacks, plug the free end of the white
line cord into the modular telephone jack for Line 1. Plug the free
end of the clear line cord into the modular telephone jack for
Line 2. Make sure the cords snap firmly into place.
6 Connect the power cord.
Plug the power adapter into the jack labeled 9V DC on the back of the
base. Plug the AC adapter on the power cord into an electrical outlet.
7 Charge the handset batteries for 16 hours.
Place the handset face down in the base. The CHARGING light on the
base goes on to show the handset is in the right position to charge the
batteries.
8 Check for dial tone.
After the batteries are charged, press L, and listen for a dial tone.
Then press l. If you do not hear a dial tone, turn to IN CASE OF
DIFFICULTY in this manual.
INSTALLATION
9002_book.1AT&T 8/12/98, 4:09 PM4