Filter
Top Products
5
Wall Installation
INSTALLATION
1 Follow Steps 1–3 under Table/Desk Installation.
2 Turn the base unit over, and attach the wall mounting base to
the lower half of the base unit. Gently press down until it snaps
firmly into place.
3 Connect the power cord.
Plug the power cord into the power jack on the back of the base. Run
the cord under the tab on the bottom of the base and under the tab on
the wall mounting base. Plug the AC adapter into an electrical outlet
not controlled by a wall switch.
4 Connect the line cord(s).
• If you have a two-line jack, use the short white line cord (see
illustration above). Insert one end of the short telephone line
cord into the telephone jack labeled L1 or L1/L2 on the rear
of the telephone base. Feed the excess line cord under the tab
on the bottom of the telephone base. Plug the line cord into a
two-line wall jack. You will be connected to Lines 1 and 2
— OR —
• If you have two separate jacks, use the short white line cord,
and the long clear line cord. Insert one end of the short white
telephone line cord into the telephone jack labeled L1 or L1/L2
on the rear of the telephone base. Feed the excess line cord under
the tab on the bottom of the telephone base. Plug the short line
cord into the standard one-line wall jack. You will be connected
to Line 1.
Insert one end of the long clear telephone line cord into the
telephone jack labeled L2 on the rear of the telephone base. Feed
Wall
Mounting
Base
2-line Wall Jack
9002_book.1AT&T 8/12/98, 4:09 PM5