Filter
Top Products
TELEPHONE OPERATION
3
Softkey Softkey
Press the softkey to select the operation displayed
on the bottom left or right of the screen.
About Softkeys
This telephone has been designed with your convenience in mind, of-
fering you many features which you can access using the two “softkeys”
shown in the illustration. By pressing the softkey below the operation
indicated on the display screen, you select that operation.
Making a Call
1 Press P, and wait for the PHONE light to go on.
2 When you hear a dial tone, dial the number.
3 See the TELEPHONE MEMORY and CALLER ID
sections of this manual for more calling options.
Answering a Call
Press P. The PHONE light goes on, and the call is connected.
Ending a Call
To end a call, place the handset in the base, or press P. The
PHONE light goes off.
Redial
The last number dialed (up to 16 digits) on this phone is stored in
redial memory until you dial another number.
1 Press P.
2 When you hear the dial tone use the softkey to select
REDIAL.
Battery Saver Feature
Set the RINGER switch on the side of the handset to OFF to prevent
the handset from ringing. (Your handset may still display Caller ID
information or page up to 15 seconds after you set the switch to OFF.)
When the ringer switch is set to OFF, the handset stays ready to use for
up to 21 days in standby mode before you have to return it to the base for
recharging. You can still use the handset to make a call or to answer a call
if you hear an extension phone ringing. When the switch is set to OFF,
the screen will not display incoming call information, but the informa-
tion will be stored in the call history.
When the ringer switch is set to ON, the handset stays ready to use for up
to 12 days.
Handset Volume
The handset volume can be set to three different levels. Each
time you press V the level changes.
Temporary Tone
NOTE: If you have touch tone service, you don’t need to use the
Temporary Tone feature.
If you have dial pulse (rotary) service, this feature allows you to
enter codes or tones needed to operate answering machines, or
use electronic banking services, calling cards, and other special
services. This feature will operate most special services; how-
ever, some services may actually require a touch tone line. To be
sure, ask the company that provides the special service.
1 Dial the call, then press *. Any buttons pressed after
this send tone signals.
2 After you hang up, the phone automatically returns to
dial pulse (rotary) dialing.
Hold
Press H to put a call on hold (The PHONE light flashes while
a call is on hold). To return to the call, press H or press P
or lift the handset of an extension phone on the same line.
Flash
Press F to activate custom-calling services such as Call Wait-
ing or 3-Way Calling. You might have to press other buttons
before or after F as explained in custom-calling instructions
provided by your local telephone company.