Filter
Top Products
underside of the wall-mounting bracket. (Make sure
you leave enough cord free to extend to the wall jack.)
6 Feed the free end of the line cord through the
rectangular opening in the center of the bracket.
7 Connect the line cord to the wall jack.
Make sure it snaps firmly into place.
8 Mount the base on the wall.
Hold the base so the mounting knobs on the wall plate
fit the keyhole slots on the base. Slide the base down
onto the knobs until it locks into the place.
If your base does not fit your wall bracket, use wall
bracket model 149A on the existing wall jack.
This bracket was designed to fit most wall phone
jacks with mounting studs, and allows you to mount the
cordless telephone base directly over an existing phone
jack. Follow the directions on the wall bracket package
to complete installation. It is available at most retailers.
9 Plug the AC adapter on the power cord into an
electrical outlet.
10 Follow Steps 6 and 7 in TABLE/DESK
INSTALLATION.
INSTALLATION
FOR WALL INSTALLATION
The wall-mounting bracket is a wedged, triangular plastic piece
attached to the bottom of the base. You'll need to attach this piece
so the thickest end of the bracket is facing the floor when you
wall-mount the base.
1 Remove the mounting bracket.
Push in on the two tabs at the large end of the
triangular mounting bracket, and lift it off the unit.
2 Follow Steps 2, 3, 4 in TABLE/DESK
INSTALLATION.
3 Connect the power cord to the base.
Plug the power cord into the jack labeled POWER on
the back of the base.
4 Guide the power cord from the jack through the
straight channel on the base.
Let the excess cord extend straight out of the end of the
channel that is farthest from the jack.
5 Connect the telephone line cord.
Plug one end of the line cord into the jack on the base.
Guide the cord from the jack through the curved
channel on the bottom of the base. Wrap any excess
line cord around the 2 crescent-shaped tabs on the
2
Wrap the line cord
around the crescent-
shaped tabs
Feed the line cord
through the center
opening, and attach
the base with the
larger end toward
the bottom
Connect the line cord to the wall jack, and
mount the base on the wall.
Remove the
mounting bracket