Filter
Top Products
1
INSTALLATION
5 Connect the power cord.
Plug the power cord into the jack labeled POWER on
the back of the base. Plug the AC adapter on the power
cord into an electrical outlet.
6 Charge the handset batteries before use.
Place the handset face down or face up in the base.
The CHARGING light on the base goes on to show the
handset is in the right position to charge the batteries.
Model 7710 requires 10 hours of charge time.
7 Set the dial mode.
If you have tone service, the phone will be ready to use
as soon as the battery is charged. If you have dial
pulse service, you’ll need to set the dial mode.
a Press
MENU
.
b Use the softkey to select SETUP (see "About
Softkeys" in TELEPHONE OPERATION, Panel 3).
c Use the softkey and continue to select NEXT until
the screen displays DIAL MODE:TONE.
d Use the softkey to select CHANGE. The screen
displays DIAL MODE:PULSE.
e Press
MENU
to exit.
Telephone line cord
AC Adapter
Modular jack
Power cord
To change back to tone dialing, follow steps a to d.
FOR TABLE/DESK INSTALLATION
1 Choose a spot near an electrical outlet and a
telephone jack.
This phone requires a modular telephone jack and a
standard electrical outlet (110v AC).
2 Install the handset battery.
a Plug the battery pack connector into the handset
and place the battery pack into the case, so the
wires rest between the battery pack and the case.
b Place the battery case cover on the handset by
sliding it on its track up over the battery case until
it snaps firmly in place.
3 Set the RINGER switch.
Set the switch on the side of the handset to ON so the
handset will ring. When this switch is set to OFF the
handset will not ring.
NOTE: If you set the RINGER switch to OFF, the handset bat-
tery will last longer. However, when the RINGER is set to OFF,
no incoming call information will appear in the display, and the
handset will not ring or page.
4 Connect the telephone line cord.
Plug one end of the telephone line cord into the jack
labeled TEL LINE on the back of the base. Plug the
other end of the line cord into a modular phone jack.
Make sure the plug snaps firmly in place.